Managed to agree a deal on a complete hayabusa turbo setup including a newly refreshed engine, MBE 9A4 ECU (another one!!), GT28/76RS turbo, manifold, injectors, throttle bodies, dry sump kit, intercooler, Turbosmart blow off valve, induction pipes and turbo plenum etc etc. The full kit was built to deliver 450 wheel hp but was never installed and has stood for a couple of years.
The full spec of the engine is:
Gen 1 Hayabusa 1300
Carrillo Conrods
Wiseco Turbo Pistons
12mm High Tensile Cylinder Stud Upgrade
Barrel Spacer
Comtec Head Gasket
APE Adjustable Cam Sprockets
SBD Dry Sump
SBD Clutch
Uprated Turbo Clutch Springs
New Clutch Plates
New Bearings
New Bearings
As the engine has been stood for a while, I will remove the head to make sure that no foreign objects that have found their way inside and to check the general condition. I will also remove the engine covers and get them powder coated orange.
I'll fit the engine later on in the year after I have used my car for a while, in the meantime, I will spend some time getting the engine ready.
I'll fit the engine later on in the year after I have used my car for a while, in the meantime, I will spend some time getting the engine ready.
No comments:
Post a Comment